The installation method of ceramic fiber board varies according to the application scenarios and specific requirements. The following are several common installation steps and precautions:

I. Installation of industrial furnaces and high-temperature equipment

Surface treatment:

Clean the surface of the construction site, including the surface of ceramic fiber board, to ensure that there is no dust, oil pollution and loose attachments.

Grind or repair the surface of the grass-roots unit so that the flatness deviation does not exceed 4 mm.

Adhesive preparation:

Binder powder and water glass are evenly mixed according to the ratio of 1:1.2.

Stirring time is not less than 5 minutes, to ensure sufficient uniformity and moderate consistency.

Installation steps:

Apply adhesive evenly on the surface of ceramic fiber board.

Ceramic fiber board is firmly bonded to the upper and lower adjacent surfaces to ensure tight splicing.

For the installation of furnace wall and roof, follow the principle of "top the wall first, bottom up".

After the installation is completed, pat the surface flat with a wooden square to ensure that the module is compacted.

Gap treatment:

Gaps between modules should be filled with ceramic fiber blankets of the same material, with a compression ratio of ≥30%, and compacted with wood square hammer.

Surface protection:

After installation, curing agent can be sprayed on the surface of ceramic fiber board to enhance the wind erosion resistance.

II. Installation of Building Decoration Industry

Surface treatment:

Clean the wall to ensure that there is no floating ash, oil pollution and other sundries.

Installation method:

Stick ceramic fiber board on the blank wall and fix it with nails.

The exterior can be further decorated.

III. Installation of processing and heat treatment industries

Wall treatment:

Clean the floating ash, oil stain and empty drum on the concrete wall.

Repair the sunken part to ensure that the flatness of the wall is within 4 mm.

Adhesive preparation:

Special bonding mortar is used, and the weight ratio of water to mortar is 1:5.

Stirring, standing for 5 minutes, and stirring again before use.

Installation steps:

Apply adhesive evenly on the back of ceramic fiber board.

Paste the ceramic fiber board on the wall to ensure firm bonding.

IV. Matters needing attention

Protective measures: Protective articles, such as gloves and goggles, should be worn during construction to prevent fiber dust from being inhaled into respiratory tract.

Environmental requirements: avoid installation in wet or strong wind environment, so as not to affect the bonding effect.

Gap treatment: the seam should be as small and uniform as possible, and high temperature resistant sealing material should be filled when necessary.

Installation of anchor: the welding position of anchor should be accurate, and it should be perpendicular to the furnace wall to avoid tilting.

Through the above steps and precautions, we can ensure the installation quality of ceramic fiber board and give full play to its heat insulation and fire prevention performance.